3164302 Crankshaft Rear Oil Seal Remover Installer Tool for Cummins

Application : For Cummins ISM L10, L10G, M11 engines. Replace with part number 3164302 2892562 Function : Remover & Install Rear Crankshaft Oil Seal,Used with Seal #4089542. Remove and install the rear crankshaft oil seal on L10/M11 engines with rear power take off. Advantage : If you are installing seal number 4089542 seal and sleeve you will need to use 3164302 or ST-221. Can prevent your rear seal from leaking. Material :Made from high standard carbon steel which can withstand corrosion, rust and impact, its heavy duty construction ensures an unparalleled long lifespan. SATISFACTION SERVICE : If you are not satisfied with our products.You can request a full refund within 30 days to support a 12 month warranty.Professional and sincere service allows you to purchase without risk!
How do you install a rearmain seal on a ISM cummins ?
1.Place the crankshaft seal guide (2) with the counterbore holes facing outward, away from the crankshaft.
Install the two guide screws (3) in opposite counterbore holes and finger tighten. Tighten the guide screws (3). Torque Value:
7 n.m [62 in-lb]
2.Do not separate the two parts of the oil seal assembly.
Make certain the raised section of the rear crankshaft oil seal capscrew flange is facing outward, away from the flywheel housing, and the
gray rubber sealing bead is facing toward the flywheel housing, as illustrated.
3.Do not push on the oil seal capscrew flange.
Push on the black inside the oil seal area while placing the oil seal assembly onto the crankshaft seal guide.
4.Make certain that the remover screw adapter is removed before the installation process.
Lubricate the threads of the installer screw (5) with multi-purpose lubricant or a suitable grease.
Position the installer plate (1) onto the rear crankshaft oil seal and the crankshaft seal guide.
Install the installer screw (5) through the washer (4) and the installer plate (1). Turn the installer screw clockwise until the installer plate (1)
positions the rear crankshaft oil seal against the flywheel housing. Tighten the installer screw. Torque Value:
34 n.m [25 ft-lb]
Remove the installer screw (5), washer (4), and the installer plate (1). Remove the two guide screws (3) and the crankshaft seal guide.
5.Rotate the oil seal capscrew flange to align the bolt holes and install the 12 capscrews.
Tighten three capscrews 120 degrees apart. Torque Value:
6 n.m [50 in-lb]
Tighten all capscrews, starting with the three previously tightened, in a crisscrossing pattern. Torque Value:
34 n.m [25 ft-lb]

Returns Accepted for this item if it's within 30 Days